Technomark M4 inline - Marking Depth and IDI Function


Page13sur47

TRAÇABILITÉCRÉATIVE
CREATIVETRACEABILITY
www.technomark-marking.com
Modèle du 29/10/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
5.1. MarkingdepthandIDIfunction

Themarkingdepthdependsontheimpactpower,andalsothedistancebetweenthestylusandthepart.
ForM4inlinemachine,adviseddistanceis3mm.WiththistuningthemarkingdepthresultisgradualfromForce1
to6.
Duringintegrationitmaybenecessarytomodifythedistancebetweenstylusandpart.Operatingrangeforeach
forceisasfollow:
 Force1:from1mmto4mm
 Force2:from2mmto6mm
 Force3:from2mmto8mm
 Force4:from2mmto8mm
 Force5:from2mmto8mm
 Force6:from2mmto8mm
Respectingthedistancestylus‐partisfundamentaltogetthedesiredmarkingdepthwithanoptimalmarkingquality
Fortheweakforces(1,2or3),ifthestylusistoofaritwillnottouchthepartduringthemarking.
Forthehighforces(4,5and6),morethestylusisfar(inthelimitofitspotentialtravelof9mm),moretheimpact
willbepowerful.
Note:markingsmallcharacterswithahighforcecancreateanillegiblemarking.
Toavoidconstraintswiththedistancesettings,TechnomarkallowsyoutousethetechnologyIDI.
When activating the IDI function (see marking parameters) a suitable marking depth is applied, whatever the
distancestylus/partis,intherangeof1to8mmtoensureaconstantrendering.
WhentheIDIfunctionisactivated,themachinemakesatestimpacttoevaluatethedistanceandadjusttheforce
usedtocorrespondtowhatisaskedfor.
IDIfunctionisavailableintwodifferentmodes:
 Flatmode:Thetestimpactisdoneateachbeginningofline.Thisisidealforflatshapes,withlittleslope.
Note:Idealtohavethesamehittingdepthonthepart,withoutworryingaboutthedistance.
 Curvedmode: The testimpact isdone ateach beginning of character. Thismodeallowsaconstantdepth
whenmarkingoncylinders,corrugatedparts,…
Note:Idealtomarkpartswithaconstantdepthwhentheypresentanunevendistancealongthelengthof
themarking.

MarkingwithIDIcurvedmodeandwithoutIDI