Technomark M4 inline - Origin Management Settings


Page46sur47

TRAÇABILITÉCRÉATIVE
CREATIVETRACEABILITY
www.technomark-marking.com
Modèle du 29/10/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
Ifthelicensenumberiscorrect,thefieldbackgroundbecomesgreen.Thenumberinthewindowtitleisthemachine
serialnumberwhichwillbeaskedtogetalicensenumber.

8.8. Originsmanagementsettings


Illustration33:Originsettingswindow

 Startup:enableordisabletheoriginsetofthemechanicsatthestart.
 Marking:Indicatetheoriginsetmodeofthemachineforamarking:
o None–nooriginset
o Begin–beforethemarking
o Fin–attheendofthemarking
o Both:beforeandaftertheendofthemarking
 Parking point: you can define a parking point for you marking head. If this option is set to «On», the
markingendwillgointhepositionxandydefined,withthemarkingspeed,insteadofcomingbacktothe
origin.Thefieldreturnallowsspecifyingthenumberofmarkingattheendofwhichtheheadwillcomeback
totheorigintoavoidpositioningissues(maximum500).Thisoptionallowsreducingthemarkingtimecycle
and/orclearsthezoneunderthemachine.







Theparkingpointreplacestheoriginreturnduringreturn markingcycles