Technomark M4 inline - IDI Calibration Procedure


Page37sur47

TRAÇABILITÉCRÉATIVE
CREATIVETRACEABILITY
www.technomark-marking.com
Modèle du 29/10/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
7.6. IDIcalibration

ThefunctionalityIDIcanbecalibratedwiththisprocedureincaseofmachinemaintenanceorfactorysettings
modification.
Thisprocedureconsistsinfoursuccessivesimilarstepsinwhichamarkingpointismadewithdifferentheights.
Thedifferentheightstocalibratearethefollowings:1mm,2.5mm,5mm,and6.5mm.
Eachstepisshownbythefollowingwindow:


Illustration22:IDICalibration

EntertheXandYpositionwherethemarkingpointwillbemadeandplacetothewrittenheight.
Thenconfirmwith tomaketheimpactandgotothenextstep.

TheIDIfunctioniscalibratedinfactoryatthedeliveryandtheIDIcalibrationprocedureisrecommendedifyou
changethemarkingheadoritscable.