Technomark M4 inline - Pause Functionality; Crossing Point Definition


Page25sur47

TRAÇABILITÉCRÉATIVE
CREATIVETRACEABILITY
www.technomark-marking.com
Modèle du 29/10/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
Inthiscase,markingisdoneforthelinesbeforethepause,andthenthemarkingtakesabreak:

UsethecommandsStartandStoptocontinueorstopthemarkinginprogress(seeMarking).

5.4.2. Addacrossingpoint–Passthroughapointduringthemarking

It’spossibletoforcetheheadtopassthroughadefinedpoint.
Whenacrossingpointiscreates,itismarkbyanorangepoint.

Inthisexampleabove,markingheadwillmoveaccordingtotheblackarrowsbetweenthetwomarkinglines
becausethereisacrossingpointinserted,insteadofusetheredpath.
Usingacrossingpointallowstodefinepatternstomovethemarkingheadwhichcanbeusefulforpartswith
complexshapes.

5.4.3. Addawaitinginput(16‐waycard)

Afilelinecanbeusedtowaitaspecificstateofaninput.
Iftheconcernedinputstateisn’treachduringthedelayallowed,themarkingisstopped.
Theconfigurationofthisfunctionisdonewiththefollowingwindow: