Technomark M4 inline - Page 28


Page28sur47

TRAÇABILITÉCRÉATIVE
CREATIVETRACEABILITY
www.technomark-marking.com
Modèle du 29/10/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
 IDI:allowsconfiguringtheIDImodeforthecurrentmarkingfile.Thereare3IDImodes:
o Off(noIDI)
o IDIflatmode
o IDIcurvedmode
FormoreinformationontheIDIuse,pleaserefertoForces–IDI.
 Mirroring mode: allows to turn over horizontally or vertically the character marking (to be read as in a
mirror).

VerticalMirror HorizontalMirror 

 SlashedZero: allows choosing appearanceof thedigitzero. By defaultthezerodigitisslashed,butitcan
appearnotslashed:

Slashedzeros Nonslashedzeros 

 Stylus Height:display the minimal/average/maximal measured values when the IDI stylus surveillance
functionisactivated.
Thisfunctionisconfiguredwiththenextwindow get byusingrightarrowofthekeyboardonthesettings
icon 


o State:enableordisablethefunction
o Delta:tolerancevaluearespreadbetween0.5mmand2.5mm
o Learning:ifthefunctionisactivated,theaverageheightiscalculatedonthefirst50markings.
o Height:havetobebetween1.5mmand9mmandfilleditifthelearningisdisable.

Whenthefunctionisactivated,themarkingmachinewillanalyzeobtainedresultsduringthemarkingand
memorizecalculatedvalues.Ifyougoovertheprogrammeddistance(Delta),analertistriggered.
Moreover,whenthearchivingfunctionisactivatedtheminimal,maximalandaveragevalues,numberof
measuresandstandarddeviationareregisteredinadditiontootherarchivedata.

