TechVision PS32E8N2 - Line Crossing

Alarm Management
DVR User Manual
73
② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video”
and “E-mail”. The alarm handling setting of exception detection alarm is similar to that of the
sensor alarm (see 9.1 Sensor Alarm for details).
③ Click “Apply” to save the settings. You can click “Exception Config” to go to the
exception detection configuration interface.
9.3.3 Line Crossing
Line Crossing Configuration:
Alarms will be triggered if someone or something crosses the pre-defined alarm line.
① Click StartSettingsCameraIntelligent DetectionLine Crossing to go to the
following interface.
② Select the camera, enable the line crossing detection and set the duration.
③ Select the direction.