TECNA WELD TESTER TE1700
In mode
Secondary voltage: displays the voltage peak value V
peak
during the
welding process. To perform this measurement, use the cables for
measuring electrodes voltage.
In mode
Secondary voltage: displays the RMS voltage value V
rms
present on the
secondary circuit, its maximum positive peak value V
peak+
and
maximum negative peak value V
peak-
. To perform this measurement,
use the cables for measuring electrodes voltage.
In modes
Energy dispensed during the weld E
weld
. To perform this measurement,
use the cables for measuring electrodes voltage.
PAGE 17
To Next Page
Loading...
