TECNA WELD TESTER TE1700
Available in NORMAL and CONTINUOUS modes
CURR - For choosing the technology of the welder used: AC, DC or CD,
and also the range with which to perform the measurement. Be sure to
choose the range appropriately because if you select one that is too
low, error CURRENT HIGH OVER RANGE will appear but if you select
one that is too high, measurement accuracy will be lost. The key is
active solely if the instrument is connected to a current transducer.
Available in NORMAL and CONTINUOUS modes
VOLT - Allows you to set the electrodes' voltage range. Be sure to
choose the range appropriately because if you select one that is too
low, error VOLTAGE HIGH OVER RANGE will appear but if you select
one that is too high, measurement accuracy will be lost.
Available in NORMAL and CONTINUOUS modes
FORCE - Allows you to set the force measuring range. Be sure to
choose the range appropriately because if you select one that is too
low, error FORCE HIGH OVER RANGE will appear but if you select one
that is too high, measurement accuracy will be lost. The key is active
solely if the instrument is connected to a force transducer.
PAGE 23
To Next Page
Loading...
