TECNA WELD TESTER TE1700
Available in NORMAL and CONTINUOUS modes
NORM/CONT - Allows you to switch from NORMAL to CONTINUOUS
operating mode and vice versa. In NORMAL mode the instrument
awaits the TRIGGER activation to acquire the spot whilst in
CONTINUOUS mode the instrument acquires current, voltage and force
values continuously. You can activate the CONTINUOUS mode only if
the welder has the AC technology, or if the current transducer is
disconnected from the instrument.
Available in NORMAL and CONTINUOUS modes
ADV - Makes advanced adjustments to the measurement process; see
the relative chapter ADVANCED MEASUREMENT CONFIGURATION.
PAGE 24
To Next Page
Loading...
