TECNA TE550 - Page 4

Instruction manual ITEM TE550 S.p.A.
4/92
CHAPTER 7 - THE WORK CYCLE ....................................................................................... 69
CHAPTER 8 - STOP BAD SPOTS ........................................................................................ 70
CHAPTER 9 - WELDS COUNTER FUNCTION..................................................................... 72
CHAPTER 10 - DESCRIPTION OF THE INTERFACE OUTPUTS........................................ 73
10.1 - WELD ERROR (WRONG)................................................................................... 73
10.2 - END CYCLE ........................................................................................................ 75
10.3 - LOCK................................................................................................................... 75
CHAPTER 11 - SELECTING THE WORK PROGRAM THROUGH EXTERNAL RECALLS 76
CHAPTER 12 - DOUBLE STROKE FUNCTION.................................................................... 77
CHAPTER 13 - OPTIONS...................................................................................................... 78
13.1 - RS-232 SERIAL INTERFACE ............................................................................. 78
13.2 - RS-485 SERIAL INTERFACE ............................................................................. 80
13.3 - INTERFACE FOR PROPORTIONAL VALVE ..................................................... 81
13.4 - INTERFACE FOR PRESSURE SENSOR ........................................................... 82
CHAPTER 14 - DESCRIPTION OF THE SIGNALS ON THE TERMINAL BOARD............... 84
14.1 - DESCRIPTION OF THE SIGNALS ON THE OPTIONAL BOARDS 50200 OR
50189............................................................................................................................. 86
CHAPTER 15 - LIST OF TE550 MESSAGES ....................................................................... 87
15.1 - SYSTEM ERRORS.............................................................................................. 87
15.2 - WORK ERRORS ................................................................................................. 88
15.3 - PROGRAMMING ERRORS ................................................................................ 91
CHAPTER 16 - TECHNICAL SPECIFICATIONS .................................................................. 92