GENERATOR LIGHT ILLUMINATES
Generator light may illuminate for a faulty alternator or when voltage is above
16V, in this case the overvoltage sensor automatically shuts down the alternator.
In both cases proceed as follows:
1. Generator switch and master switch: OFF.
2. Generator switch and master switch: ON.
If the problem no longer persists, normal alternator charging will resume and the
warning light will turn off proving voltage surcharge was temporary; no further
action is required.
If light remains illuminated, a generator malfunction is confirmed. In this case, set
Generator switch to OFF and continue flight on battery power alone; the battery is
capable of supplying the electrical system for about 26 min. with normal flight
loads including operation of: com/nav, flap and trim.
TRIM SYSTEM FAILURE
LOCKED CONTROL
In case the trim control should not respond, act as follows:
1. Check switch for correct position
2. Adjust speed to control aircraft without excessive stick force
3. Land aircraft as soon as possible.
RUNAWAY
If trim position indicator reads displacement without pilot's action on trim
control, follow procedure below:
1. Trim power switch OFF
2. Adjust speed to control aircraft without excessive stick force
3. Land aircraft as soon as possible.
To Next Page
Loading...
