6
codice 09MAXX001
versione EN
revisione 01
Use and Maintenance Manual
MaxX
1.8
Personal protective
equipment (PPE)
The staff referred to in the previous paragraph must wear an
adequate safety distance from the parts clamped on the
magnetic equipment, with special attention when in vertical or
suspended (this distance must be suggested by the plant
operator in accordance with the regulations)
.
The staff must
also wear appropriate safety clothing. Protective footwear is
mandatory, while the need for
headsets, helmets and goggles must be assessed by the
User. Loose fitting clothes or articles that could be trapped by
moving parts are prohibited.
(see chapter 8)
1.9
General safety warnings
The rules and recommendations below are in compliance
with the current safety regulations, on which they are
based. TECNOMAGNETE S.p.A. declines all responsibility for any
damage caused to persons or things deriving from failure to
observe the safety regulations in force and the instructions given
below.
Machine safety systems must be selected and installed on
the basis of the following requirements:
be under the technical responsibility of qualified
personnel
be integrated with technical compliance and with
appropriate control systems
installations must be made in such a way that they can
not be neutralized or tampered with
All designated operators must respect and implement the
following and scrupulously adhere to the regulations on
accident prevention in force in the country of installation and
on the use of the MaxX. All ordinary and extraordinary
maintenance must be performed with stationary system and
with structure not hooked to the crane etc.
To avoid the danger of accidental connections during
maintenance operations, attach a warning sign on the control
panel with the words:
MAINTENANCE IS UNDERWAY
All operations of transport, installation, use, ordinary and
extraordinary maintenance on the MaxX must only be carried
out by the personnel identified in section 6 of chapter 1.
The permanent-electro magnetic system can only be used for
the applications indicated in the manual and only in
combination with devices and components recommended and
authorized by TECNOMAGNETE S.p.A.
1.10
Emergency drill
In an emergency, it is recommended to follow the procedures
given in the operation and maintenance manual of the machine
on which the MaxX is installed. In the event of fire, use the
devices provided to extinguish the fire, taking care never to use
water on electrical parts
(considering however that MaxX is not
made up of electrical parts).
1.11 Unintended or improper use
MaxX is not designed or constructed for operation in explosive
atmospheres.
Unintended use may:
cause injury to personnel
damage the system or other equipment
diminish reliability and performance.
MaxX cannot be used for purposes other than those
recommended and in compliance with the intended use,
avoiding the following in particular:
unsuitable parameters of use
defective or lack of maintenance
use of inappropriate materials
failure to follow instructions
uncertain or insecure clamping of MaxX system or parts
thereof
In the events of doubts over the appropriate usage,
contact TECNOMAGNETE S.p.A. to determine whether it is use
for which the system was intended or otherwise.
To Next Page
Loading...