TECO A510s Series - Page 50

49
LED display Corrective action
 Check 10-29 and 10-03
HPErr
Model
selection error
 Check inverter capacity
setting 13-00.
SE07
PG card error
 Install PG feedback
card.
 Check control mode.
 Set right type for PM
Encoder Type (22-08)
and power on again.
SE08
PM Motor
mode error
 Check control mode.
SE09
PI setting error
 Check pulse input
selection (03-30) and
PID source (10-00 and
10-01).
FB
(flash)
PID feedback
breaking
 Check feedback wiring
 Replace feedback
sensor.
USP
(flash)
Unattended
Start
Protection
 Remove run command
or reset inverter via
multi-function digital
input (03-00 to 03-07 =
17) or use the RESET
key on the keypad to
reset inverter.
 Activate USP input and
re-apply the power.
STP0
Zero Speed
Stop Error
 Adjust frequency
command
STP2
External
Terminal Stop
Error
 Remove the run
command from external
terminal
EnC
Encoder Error
 Check encoder wiring
 17-07 PG pulse number
setting is not
corresponding to the
encoder.
 Replace the encoder.
LED display Corrective action
RunEr
Wrong running
direction Error
 Revise the command
among 11-00, jog and
DI control to see if any
difference
PArEr
Parameter
setting error
 Please refer to our
instruction manual for
correct setting
STP1
Direct start
warning
 Remove the run
command from the
terminal first, and
enabled later.
FirE
Fire mode
enabled
 Check the environment
and confirm the fire
status. If no fire, turn off
the power and power on
again.
AdCEr
Voltage on C/B
error
 Check the voltage on
the control board.
EPErr
EEPROM Save
error
 Restore factory setting,
then cut off the power
and power on again.
 If warning again,
replace control board.
bdErr
Control board
error
 Replace the control
board.
Parameter
Lock
 Lifting the parameter
lock key code, to enter
the correct parameter
for 13-07
Set password
failed
 Enter the correct
parameter for 13-07 to
enable the parameter
lock key