TECO JSDAP-100A3 - Timing Diagram of Tool Turret Homing

5-81
5-7-4 Timing Diagram of Tool Turret Homing
Servo ON
Tool Turret
selection (Pos 1)
Tool Turret
selection(Pos 2)
Tool Turret
selection(Pos 3)
Tool Turret
selection(Pos 4)
Position Trigger
(PTRG)
Control Mode
switching (MDC 1)
Control Mode
switching (MDC 2)
Motor Speed (rpm)
In Position (INP)
Tool turret display
(DO 1)
Tool turret display
(DO 2)
Tool turret display
(DO 3)
Tool turret display
(DO 4)
Alarm (ALM)
Tool Turret No. 6 selected
Tool Turret No.1 displayed
Tool Turret No.6 displayed
Homing Operating