** Door dual custody
outside
Dual Custody access is required at the “OUT” reader
Secondary override is active
Door Contact is unsealed with no valid door command
Interlock input(s) are unsealed
* Door interlock
override
If the interlock has been overridden
Duress PIN code entered at door keypad
Lock output is de-activated to lock the door
** Door low security
inside
Card and PIN required to access at the “IN” reader
** Door low security
outside
Card and PIN required to access at the “OUT” reader
Door Open command is active (to unlock / start shunt)
Door Contact is unsealed after shunt timer has expired
The override time zone assigned to the door is valid
The override time zone is inhibited
An event is generated at random when the door is
accessed
When the door is LOCKED and the door is CLOSED.
Shunt warning timer is running
Lock output is active to unlock the door
Fault detected on reader (Comms / tamper / etc)
Cable tamper / fault detected on lock relay wiring
* Denotes rule can only be activated as a result of another door macro.
** Denotes rule can only be activated as a result of another door macro and the function of the door (the
macro input is always true if the function is set in the programming)
*** Denotes the event is currently not enabled.
# User with the ‘Privilege’ attribute set can override the ‘Reader disabled’ function.
To Next Page
Loading...
