Table 9: Other macro event descriptions
Area in access (99 events, 1 per
area)
Classic & IP
Extended Mode
Input(s) in alarm in area (99 events,
1 per area)
Classic & IP
Extended Mode
DGP on Intelligent Controller sub-
LAN is offline.
* Controller battery test
active
The battery test on this Controller is
running (1 event)
* Controller battery test
fail
The battery test failed on this
Controller (1 event)
Low battery condition exists on the
Controller (1 event)
Fuse Fail condition exists on the
Controller (1 event)
Mains fail condition exists on the
Controller (1 event)
Controller is not communicating
with the Challenger (1 event)
* Controller siren active
The siren output (16th relay) is
active (1 event)
Siren fail (siren tamper) condition
exists on this Controller (1 event)
Cabinet tamper condition exists on
this Controller (1 event)
System relay assigned to this DGP
is active (16 events, 1 per relay).
The first 16 relays on DGP can also
be activated by physical relay
function.
Input on this DGP is unsealed (16
events, 1 per input)
Relay connected to this DGP is
active (255 events, 1 per relay). If
the physical relay is numbered
higher than the first 16 in the DGP,
then it can only be activated by
door macro.
RAS on Intelligent Controller sub-
LAN is offline (16 events, 1 per
RAS address)
When the number of people in any
region reaches the present limit
(255 events, 1 per region)
* Denotes the event is currently not enabled.
** Not available in IP Direct mode