EasyManuals Logo
Home>Tecsun>Receiver>S-2000

Tecsun S-2000 User Manual

Tecsun S-2000
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
9
LISTEN TO THE RADIO
Press the POWER button to turn on the radio, select your band by pressing the FM, MW/LW, SW,
or AIR button.
There are three methods to tune in the radio station:
USING TUNING KNOB
The TUNING knob can be used to tune stations. Select FAST or SLOW tuning with the STEP
button, under the tuning knob. FAST/SLOW tuning is shown in the chart below for each band.
If you want to LOCK the tuning knob press the STEP button for about 3 seconds. Do a quick,
short press to unlock it.
FM MW LW SW AIR SSB
FAST 0.1MHz 9/10kHz 9kHz 5kHz 0.025MHz 5kHz
SLOW 0.01MHz 1kHz 1kHz 1kHz 0.001MHz 1kHz/BFO
Note: Be sure to fully extend the telescopic antenna when listening to SW, FM and AIR. The
swivel AM (MW/LW) antenna is located at the top of the radio; swivel it for best AM (MW/LW)
reception.
Quick, short, sequential presses of the / buttons enables tuning up or down frequency. A
longer press engages Auto Tuning. During Auto tuning, the radio scans from one station to the
next, stays on the new station for 5 seconds and then moves on.
To stop Auto Tuning, press any key.
USING / BUTTON TUNING
DIRECT FREQUENCY ENTRY
Use this method when the desired frequency of a radio station is known. MW and SW frequencies
are entered in kilohertz (kHz), e.g. 567 kHz or 15100 kHz; FM and AIR frequencies are entered in
megahertz (MHz), e.g. 100.8 MHz, ignoring the decimal point. Use the numeric keypad to enter
the frequency directly.
Note:
- No need to enter decimal point for FM and Air Band when input the frequency numbers. For
example, FM 89.0 MHz, Just ENTER 8 9 0 or FM 104.0 MHz, ENTER 1 0 4 0. (or press 8 9
ENTER, and 1 0 4 ENTER).
- For SW band in between 1711~2999kHz, simply input the frequency number then press ENTER
to confirm. For example, SW 2650kHz, just input 2650 ENTER . If SW frequency in between
3000~29999kHz, just input the numbers directly (no need to press the ENTER button to confirm).
- For any mis-typed number, simply press DELETE button to cancel it.
- will appear on the display, when entering any outbound frequency.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tecsun S-2000 and is the answer not in the manual?

Tecsun S-2000 Specifications

General IconGeneral
BrandTecsun
ModelS-2000
CategoryReceiver
LanguageEnglish

Related product manuals