Tecsun S-2000 - Listening to Whats Stored

12
LISTENING TO WHAT'S STORED
- Turn on the radio and go to the correct page by pressing PAGE and entering it with the numeric
keypad or using the TUNING knob or / button.
- Press and release the VM/VF button with a "BB" sound and
notice that the PAGE and PRESET show in the display's
upper right corner.
- To go from one memory to another give a quick, short press
to either the / button, or rotate the TUNING knob.
- To auto-scan memory press one of the / buttons for
about 2 seconds with a "B" sound and notice that
flashes in the upper right corner. The radio scans from one
memory to another, staying on each memory for about 5
seconds. To stop the scan, short press any button with a
"B" sound.
To go to a memory you already know, direct key in two digits of the memory location.
NOTE:
1. There is no auto-scan memory function in AIR and SW SSB band.
2. If the page is 50, only key in 1-9 of the memory location.
3. When " - - - - " appeared in the display with a "BB" sound after you key in a number of the
memory, means there is nothing stored.
4. When " " appeared with a long "B" sound, means the number keying in excess.
PAGE / PRESET
PRESET changing
flashing