Need help?Do you have a question about the TeeJet Technologies 844E and is the answer not in the manual?
General| Brand | TeeJet Technologies |
|---|---|
| Model | 844E |
| Category | Paint Sprayer |
| Language | English |
Details connecting the console to the vehicle's power supply.
Sets the desired measurement units (US, Imperial, Metric, etc.).
Selects whether the system uses a flow meter or pressure transducer for regulation.
Calibrates the flow meter by inputting pulse rate or performing tests.
Sets maximum rating and calibrates low pressure for the transducer.
Enters the distance between nozzles for accurate rate calculations.
Specifies the number of spray tips for each boom section.
Selects bypass or throttling mode for the pressure regulating valve.
Calibrates speed sensors (wheel or radar) using manual or automatic methods.
Sets the specific gravity for different liquid densities in calculations.
Sets the desired application rate based on selected units.
Selects nozzle color or programmable tip for accurate rate calculation.
Provides steps for pre-spraying checks and system verification.
Guides on initiating and conducting the spraying operation.
Addresses issues with flashing application rate units due to discrepancies or programming.
Troubleshoots problems related to the flow meter turbine symbol.
Guides calibration using a known volume of water pumped through the meter.
Calibrates by comparing measured flow to calculated flow based on tip size.
To Next Page