Tefcold SFI Series - 4- Head Fridge and Island Array; Electrical Connections

12
EN
3.3.2.4 HEAD FRIDGE AND
ISLAND ARRAY
It is the island group consisting
of head fridges, which are placed
at the head of the group, in addition
to the back-to-back array. It is not
necessary to leave air gaps between
head fridges and other fridges. A
visual regarding the device’s lay-out
is presented on Image GG.
WARNIN
FIRE HAZARD
You denitely shall leave
the ventilatin slits
and surroundins open
within the scope of the
rules stated on the uide.
Denitely do not prevent
air ow. Denitely do not
cover.
3.4 ELECTRICAL
CONNECTIONS
This device works with 220-240V/
50-60 Hz, 110-127/60 Hz alternating
current. Check this value from the label
at the back of the device (Image JJ ). The
aspects you shall pay attention to while
using the device are stated below:
•The plug shall be easily accessed
also after the device is placed.
•Signified voltage shall be equivalent
to grid voltage.
•Extension cables or multi-plugs
shall not be used.
•Damaged electric cable shall be
replaced by a professional electricity
expert.
•A grounded socket, which is
protected by a fuse with sufficient
capacity (that has 10-16 A strength),
shall be used for the device.
•In case there is an electrical
problem with the device, the device
shall not be used until it is repaired.
Electric shock may occur.
WARNIN
FIRE HAZARD
Before accessin to the
connection terminals, all
circuits power must be
disconnected.