Tefcold SFI Series - Safety Information and Environmental Warnings; Before Operation of the Equipment

7
EN
2 SAFETY INFORMATION
AND ENVIRONMENTAL
WARNINS
2.1 BEFORE OPERATION OF
THE EQUIPMENT
It is important to act in
accordance with the aspects stated
below before operation of the
equipment with regards to safety,
performance and energy consumption.
NOTE
e lubricant in the cooler
part of the equipment
may be displaced durin
transportation and transfer
operations. For this reason,
wait minimum 4 to 6 hours
before operatin the
equipment.
The location of assembly of the
equipment affects the performance and
energy consumption of theequipment
(Chapter 3.1). When determining the
location of assembly, the Authorized
Service will provide information and
recommendations; however, the
final decision shall be left to the user.
Depending on the final decision to
be given by the consumer, in case of
experiencing any problem due to the
location of the equipment, all
responsibility shall be borne by the
consumer, and the equipment shall
be considered out of warranty due to
problems that may emerge due to such
positioning.
SUESTION
In order for the equipment to
be used in the most ecient
way, the ambient temperature
where it is located must be
considered. e ambient
temperature in the area where
the equipment will be used
must be 25°C and the humidity
60% R.H.
WARNIN
FIRE HAZARD
If the refrierant as
written on the label at the
bac side of the equipment
is R290, in case of substance
leaae, mae sure that the
necessary ventilation has
been provided in order to
prevent from the mixin of
the inammable as with
air. Because the mentioned
as is environment-friendly
but inammable. In case
of leaae, eep the heat
sources that may lead to
inammation away from the
equipment.