Tefcold SFI Series - Thermostat Adjustments (Cra); 1-General Information and Instructions; 2- Set Temperature; 3- Manual Defrost

19
EN
4.5 THERMOSTAT ADJUSTMENTS
(
CRA
)
4.5.1GENERAL INFORMATION AND INSTRUCTIONS
The explanations regarding the sybols on the thermostat and general informtion
about the settings are given below. Thermostat visual is presented on Image
H4H4 .
1) [
SET
4s
] - Dsplays the control setpont. Ext the control setpont and save the
changes.
2) [
AUX
] - Cancel and return to standard mode. Swtch furnture lghtng on/off.
Actvate/deactvate AUX output.
3) [
FNC
] - Set a lower value. Actvate/deactvate energy-savng mode.
4) [
] - Set a hgher value. Actvate manual defrostng.
[ ]- Compressor s swtched on
[
] - Defrostng n progress
[
] - Evaporator fan s swtched on
[
HACCP
] - Stored HACCP alarm
[
°C
] - Temperature unt s the degree Celsus
[
°F
] - Temperature unt s the degree Fahrenhet
[
AUX
]- Furnture lghtng
[
]- Devce s n standby mode
[
]- Energy-savng mode s actve
[
]- Compressor requres mantenance
4.5.2 SET TEMPERATURE
To set the operatng temperature of your devce, press the [
SET
4s
] key.
The Setpoint value appears on the display. Use the [ ]/[
FNC
] keys to set the
desired value.Press the [
SET
4s
] to confirm the modification.
4.5.3 MANUAL DEFROST
Hold down the [ ] key for 5 seconds on the thermostat.