Teka CML 45 - Water Hardness and Language Settings; Setting Water Hardness

English
111
Setting water hardness
The descale message is displayed after the appli-
ance has been operated for a factory set period of
time calculated on the basis of the maximum quan-
tity of limescale which may be contained in the wa-
ter used.
The operating period can be extended if required,
making descaling less frequent by programming the
machine on the basis of the real lime content in the
water used.
Proceed as follows:
• Remove the “Total Hardness Test” strip (at-
tached to page 2) from its packaging then dip it
fully in the water for a few seconds,
Then remove and wait about 30 seconds (until it
changes colour and forms red squares).
• Switch the machine on by turning the knob
(A7) (fig. 5).
• PresstheMENUbutton(B6)thenpresstheNEXT
button (B7) repeatedly until the appliance dis-
plays“WATERHARDNESS4”.
• Press the CHANGE button repeatedly until
the number coincides with the number of red
squares on the test strip (for example, if there
are 3 red squares on the test strip, press the but-
tonuntil“WATERHARDNESS3”isdisplayed).
• PresstheOKbutton(B9)toconrm.
The coffee maker is now programmed to provide
the descale warning when necessary based on
the actual hardness of the water.
Resetting default values (reset)
If you change the original values, the default values
can be reset as follows:
• PresstheMENUbutton(B6)thenpresstheNEXT
button (B7) repeatedly until the appliance dis-
playsRESETTODEFAULTNO.
• PresstheCHANGEbutton(B8)andtheap
pliancedisplays“RESETTODEFAULTYES”.
• Press the OK button (B9) to reset the default
values.
• Theapplianceisnowresettothedefaultset-
tingsandthe“READY”messageisdisplayed.
CHANGING THE LANGUAGE
Tochangethelanguage,presstheCHANGEbutton
for at least 5 seconds until the appliance displays
the installation message in various languages.
Select the required language as described in the
section “Using the appliance for the first time”.
TURNING THE APPLIANCE
OFF
Eachtimetheapplianceisturnedoff,itperformsan
automatic rinse cycle which cannot be interrupted.
Danger of burns! During rinsing, a little hot
water flows from the coffee spouts. Avoid contact
with splashes of water.
Toturntheapplianceoff,turntheON/OFF/standby
knob (A7). The appliance performs the rinse cycle
then goes off.
N.B.! If the appliance is not used for an ex-
tended period, place the main switch on the back of
the appliance in the 0 position (A23).
TECHNICAL SPECIFICATION
Voltage:220-240V~50/60Hzmax.10A
Absorbed power: 1350 W
Pressure: 15 bars
Water tank capacity: 1.8 litres
SizeLxHxD:560x450x550mm
Weight: 26 kg
The appliance complies with the following
ECdirectives:
• LowVoltageDirective2006/95/ECand subse-
quent amendments.
• EMC Directive 2004/108/CE and subsequent
amendments.
Materialsandaccessoriescomingintocontactwith
foodconformtoEECregulation1935/2004.