Teka CML 45 - Displayed Messages and Remedies; Fill Tank and Grounds Container Messages; Coffee Grinding and Pre-Ground Coffee Messages

English
113
DISPLAYED MESSAGES
FILLTANK
GROUND TOO FINE ADJUST
MILL alternating with PRESS
OK
EMPTYGROUNDS
CONTAINER
INSERTGROUNDS
CONTAINER
• The grinding is too ne
and the coffee is delivered
too slowly.
• Themachinecannotmake
coffee as there is air in the
hydraulic circuit.
• The grounds container
(A4) is too full or more
than 3 days have passed
since you last made coffee
(this guarantees correct
hygiene of the machine).
• Aftercleaning,thegrounds
container has not been
replaced.
ADDPRE-GROUNDCOFFEE
• Fill the tank with water
and/or insert it correctly,
pushing it as far as it will
go.
• Turn the grinding ad-
justment knob one click
clockwise towards “7”.
• Press the OK button (B9)
and deliver water from the
cappuccino maker
• Empty the grounds con-
tainer and clean, then re-
place.
Important: when removing
the drip tray, the grounds
container MUST be emp-
tied, even if it is not com-
pletely full.
If this is not done, when
you make the next coffees,
the grounds container may
fill up more than expected
and clog the machine.
• Opentheservicedoorand
insert the grounds con-
tainer.
• Extract the appliance and
place pre-ground coffee in
the funnel.
• Empty the funnel with
the help of a knife as
described in the section
“Cleaning the pre-ground
coffee funnel”.
• The water tank is empty or
positioned incorrectly.
• The “pre-ground coffee”
function has been selected
without placing any pre-
ground coffee in the funnel.
• Thefunnel(A21)isblocked
DISPLAYEDMESSAGE POSSIBLECAUSE
REMEDY