English
105
If it is removed, it will not be possible to make the
coffeeandtheappliancewilldisplay“GROUNDTOO
FINEADJUSTMILLANDPRESSOK”.
To use the appliance again, press the OK button (B9)
and deliver water from the cappuccino maker for a
few seconds.
CHANGING THE QUANTITY
OF COFFEE IN THE CUP
The appliance is set by default to automatically
make the following types of coffee:
• Short coffee when the button (B3) is
pressed.
• Standardcoffee when the button (B4) is
pressed.
• Long coffee when the button (B5) is
pressed. To change these quantities, proceed as
follows:
• Press the button corresponding to the quan-
tity you want to change ( , or ) for
at least 3 seconds then release until the mes-
sage “PROGRAM QUANTITY” is displayed and
coffee delivery commences.
• Whenthecoffeeinthecupreachestherequired
level, press the same button again to memorise
the new amount.
The appliance is now reprogrammed with the new
settingsanddisplays:“READY”.
ADJUSTING THE COFFEE
MILL
The coffee mill is preset in the factory to make
coffee correctly and should not require adjusting
initially.
However,ifaftermakingtherstfewcoffeesyou
find that delivery is either too fast or too slow (a drop
at a time), this can be corrected by adjusting the
grinding adjustment knob (fig. A17) (fig. 11).
Important!
The grinding adjustment knob
must only be turned when the coffee mill is in
operation.
For slower delivery and
creamier coffee, turn one
click anticlockwise (finer
pre-ground coffee).
For faster delivery (not a
drop at a time), turn one
click clockwise (coarser pre-
ground coffee).
(Coffee has been used to
factory test the appliance
and it is therefore complete-
ly normal for there to be
traces of coffee in the mill.
It is, however, guaranteed to
be new.)
MAKING ESPRESSO
COFFEE WITH PRE
GROUND COFFEE (INSTEAD
OF BEANS)
• Pressthebutton(B7)(g.15)toselect
the pre-ground coffee function. This disables the
coffee mill function.
The appliance now displays the message:
“READYPRE-GROUND”.
• Extractthemachinebypullingitoutwardsusing
the handles.
• Liftthecentrallid,placeonemeasureofpre-
ground coffee in the funnel (fig. 16), push the
appliance in then proceed as described in the
chapter “Making coffee using coffee beans”.
N.B.:Youcanmakejustonecoffeeatatimeby
pressing the (B3), (B4) or (B5) button
once only.
• Afterusingthemachinewithpre-groundcoffee,
to go back to making coffee using beans, deac-
tivate the pre-ground coffee function by press-
ing the button (B2) (fig. 6) again to enable
the coffee mill.
NOTE 1:Never introduce pre-ground coffee when
the machine is off or it could spread through the
inside of the appliance.