Teka CML 45 User Manual

English
103
9. “HOTWATERPRESSOK”isdisplayed.
10. Press the OK button (B9)
The appliance begins delivering hot water and
themessage“PLEASEWAIT...“isdisplayed.
After the flow of hot water stops, the appliance
automaticallyresetsto“READY”status.
Replacing the filter (“Filter Reset”)
When “REPLACE FILTER” is displayed or after 2
months of use (see date indicator), the filter must
be replaced:
1. Remove the exhausted filter;
2. Remove the new filter from the packaging.
3. Slide the pointer of the date indicator (see fig.
28) until the months of use are displayed (the
filter lasts about 2 months).
4. Insert the filter in the water tank and press
it until it touches the bottom of the tank (see
fig. 28).
5. Fill the water tank and insert in the coffee maker;
6. Turn the cappuccino maker outwards and place
a container underneath (min. capacity 100 ml).
7. PresstheMENUbutton(B6)toenterthemenu;
8. PresstheNEXTbutton(B7)until“FILTERRESET
NO”isdisplayed.
9. Press the CHANGE button (B8) until “FILTER
RESETYES”isdisplayed.
10. Press the OK button (B9) to confirm.
11. “HOTWATERPRESSOK”isdisplayed.
12. Press the OK button (B9) again. The appliance
begins delivering hot water and the message
“PLEASEWAIT...“isdisplayed.
After the flow of hot water stops, the appliance
automaticallyresetsto“READY”status.
Removing the filter
If you want to use the appliance without a filter, you
must remove it and notify the appliance of its re-
moval as follows:
1. PresstheMENUbutton(B6)toenterthemenu.
2. Press the NEXT button (B7) until “UNINSTALL
FILTER”isdisplayed.
3. Press the OK button (B9). The appliance auto-
maticallyresetsto“READY”status.
TURNING ON AND HEATING
UP
Eachtimetheapplianceisturnedon,itperformsan
automatic preheat and rinse cycle which cannot be
interrupted.
The appliance is ready for use only after completion
of this cycle.
Danger of burns! During rinsing, a little hot
water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance on, turn the knob (A7)
(totherightorleft)(g.5).“HEATINGUP...PLEASE
WAIT” is displayed.
Afterheating,themessage“RINSING”isdisplayed.
As well as heating the boiler, the appliance also
heats the internal circuits by circulating hot water.
The appliance is at temperature when the mes-
sage “READY STANDARD TASTE” is displayed.
MAKING COFFEE USING
COFFEE BEANS
1. The appliance is preset to make coffee with a
standard taste. You can also choose coffee with
an extra-light, light, strong or extrastrong taste.
To choose the required taste, press the
button (B2) (fig. 6). The required coffee taste is
displayed.
2. Place 1 cup under the spouts to make 1 coffee
(fig. 7) or 2 cups for 2 coffees (fig. 8).
Lower the spouts as near as possible to the cup
for a creamier coffee (fig. 9).
3. Press the button (B3) to make a short
coffee (fig. 10), the button (B4) for a standard
coffee and the button (B5) for a long coffee.
To make 2 coffees, press the button twice (with-
in 2 seconds).
To change the quantity of coffee the appliance
delivers automatically into the cup, proceed as
described in the following chapter. (The appli-
ance now grinds the beans and starts delivering
the coffee into the cup.

Teka CML 45 Specifications

General

Brand	Teka
Model	CML 45
Category	Coffee Maker
Language	English