1Ć13
The knob labels always show the knob
assignments, the parameters that the knobs
will control. The bottom half of each knob
label shows the current value of the
parameter. When you turn a knob, you will
see the current value change, and you will
see the change on the display and on any
displayed menus that show the parameter.
Any time knob labels change they will
change color. When you turn a knob, the
labels return to normal.
This selector lets you remove a trace from the
display. First select (highlight) the trace you
want removed by touching it, then touch this
selector. A popĆup menu will ask you to select
remove or clear. See page 3Ć212.
The Pan/Zoom selector lets you expand any part
of a trace using horizontal magnification. See
page 3Ć107. When the knobs are assigned to
vertical size and offset, this selector may change
to provide more vertical control. See page 3Ć221.
You can use the Keypad Menu to
enter a numeric value for your
parameter instead of turning the
knob until the parameter is set. Touch
number selectors as if you were
typing the number, and end your
entry by touching the Enter selector.
CHS changes the sign of your
number, Back Space lets you correct
errors. The p (pico), n (nano),
m (micro), and m (milli) selectors let
you scale your number.
If you touch the wrong knob label
by accident, the top two selectors
let you choose the other knob
parameter for Keypad Menu
manipulation.
The Coarse, Medium, and
Fine selectors affect the
knob resolution. When
set to coarse, each knob
click represents a greater
change than when set to
medium or fine.
The Set to Min and
Set to Max selectors
let you quickly set a
parameter to either
extreme of its range of
adjustment.
To Next Page
Loading...
Need help?
General
