Appendix E: Messages
Appendices
EĆ2
Calculated waveforms cannot be measured in hardware mode.
$ !# "! % " " ! $"#" ""
" ! " #"!
Change in channel (#, Unit) configuration.
" ! ! $" " $ ! %
" " ! "
Channel (#, Unit) powered down during mainframe operation Ċ
Cycle power to continue.
" ! ! $" " $ ! %
" " ! "
Channel (#, Unit) poweredĆup during mainframe operation Ċ
Cycle power to utilize.
" ! ! $" " $ ! %
" " ! "
Channel (#, Unit) was not maintained at desired calibration delay
value.
"! "" " #"" " !%!" """ " #!" "
% " ! %# " #! " %
#!" "# " # % # %# "# "
Delay Compensate !" " !" " " %
#!" "
Connect a 50ĆW terminator to the selected channel and press
Proceed when ready.
! $" %# " #" " " " ! "
" ! %# " "# " Proceed
!" %# "# " Proceed !" $"#" "" " " "
" " $ " !#"! $ # "
Delay adjust calibration failed, can't find transition.
# ! ! " " " " "
" " $ " !" #" !! " !% "# "
Proceed !"
Delay adjust measurement on reference channel failed Ċ Can't
find transition.
# ! ! " " " " "
" " $ " !" #" !! " !% "# "
Proceed !"
To Next Page
Loading...
