General Information
Repackaging
For
Shipment
If this instrument is to be shipped by commercial transportation, it should be
packaged in the original manner. The carton and packaging material in which your
instrument was shipped to you should be retained for this purpose.
If the original packaging is unfit for use or is not available, repackage the
instrument as follows:
1.
Obtain a corrugated cardboard shipping carton having inside dimensions at
least six inches greater than the instrument dimensions and having a carton
test strength of at least 275 pounds.
2.
If the instrument is to be shipped to a Tektronix Service Center for service or
repair, attach a tag to the instrument showing the following: owner of the
instrument (with address), the name of a person at your firm who can be
contacted,
complete instrument type and serial number, and a description of
the service required.
3. Wrap the instrument with polyethylene sheeting or equivalent to protect the
outside finish and prevent entry of packing materials into the instrument.
4.
Cushion the instrument on all sides by tightly packing dunnage or urethane
foam between the carton and the instrument, allowing three inches on each
side.
5. Seal the carton with shipping tape or with an industrial stapler.
6. Mark the address of the Tektronix Service Center and your return address on
the carton in one or more prominent locations.
2465B/2455B/2445B Operators
1-5
To Next Page
Loading...
Need help?
General
