Getting Started
You can change t
he instrument to be used to control other devices via the GPIB
port by switching the instrument to be a GPIB Controller referred to as the
“Controller Mode”.
To switch the instrument between these two modes, use the GPIB
Device-Controller Utility found in the Windows Start menu under Programs
> Tektronix DSA8200 > GPIB Device-Controller Utility. Starting this utility
displays the TekGpibSwitcher screen which allows you to switch the instrument
between the two modes.
NOTE. Swit
ching the mode causes the instrument to automatically reboot.
1-6 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
