Commands Listed in Alphabetical Order
MATH2:FILTER:
RISETIME?
might return MATH2:FILTER:RISETIM E
1.00000000000E–009
, indicating that the risetime of the math filter used for the
Math 2 waveform is set to 1 ns.
MATH<x>:NUM
avg
This command sets or queries the number of waveforms to av erage for a math
waveform.
Group
Math
Syntax
MATH<x>:NUMavg <NR1>
MATH<x>:NUMavg?
Related Commands
MATH<x>:DEFine
Arguments
NR1 is the number of waveforms to average for a m ath waveform.
Examples
MATH4:NUMAVG 25 sets the number of waveforms to average for the Math 4
waveform to 25.
MATH2:NUMAVG? might return MATH2:NUMAVG 15, indicating that the number of
waveforms to average for the Math 2 waveform is 15.
MATH<x>:POSition
This command allows you to set or query the vertical position of the specified
math waveform. The math waveform is speci fied by x, which can be 1 through
8. This is equivalent to specifying a math waveform in the Waveform section of
the Vertical Setup dialog box and then entering a value for Position in the Setup
section.
Group
Math
Syntax
MATH<x>:POSition <NR3>
MATH<x>:POSition?
Related Commands
MATH<x>:SCAle
2-218 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
