Commands Listed in Alphabetical Order
FEC10664 selec
ts clock recovery for the 10.6642 Gb/s bit rate, in accordance
with the ITU-T G.975 Recommendation.
FEC10709 sele
cts clock recovery for the 10.709225 Gb/s bit rate, in
accordance with the ITU-T G.709 Draft Recommendation.
INFIniband
selects clock recovery for the 2.500 Gb/s bit rate, in accordance
with the InfiniBand standard.
INPUT_DATA
selects the data inputs of the clock recovery module as the
triggering source.
OC1 selec t
s clock recovery for the 51.84 Mb/s bit rate, in accordance with the
Sonet/SDH OC-1/STM-0 standard.
OC3 selec
ts clock recovery for the 155.52 Mb/s bit rate, in accordance with
the Sonet/SDH OC-3/STM-1 standard.
OC9 sele
cts clock recovery for the 466.56 Mb/s bit rate, in accordance with
the Sonet/SDH OC-9/STM-3 standard.
OC12 se
lects clock recovery for the 622.08 Mb/s bit rate, in ac cordance with
the Sonet/SDH OC-12/STM-4 standard.
OC18 s
elects clock recovery for the 933.12 Mb/s bit rate, in accordance with
the Sonet/SDH OC-18/STM-6 standard.
OC24
selects clock recovery for the 1 .24416 Gb/s bit rate, in accordance with
the Sonet/SDH OC-24/STM-8 standard.
OC3
6
selects clock recovery for the 1 .86624 Gb/s bit rate, in accordance with
the Sonet/SDH OC-36/STM-12 standard.
OC
48
selects clock recovery for the 2 .48832 Gb/s bit rate, in accordance with
the Sonet/SDH OC-48/STM-16 standard.
OC
96
selects clock recovery for the 4 .97664 Gb/s bit rate, in accordance with
the Sonet/SDH OC-96/STM-32 standard.
O
C192
selects clock recovery for the 9.95328 Gb/s bit rate, in accordance
with the Sonet/SDH OC-192/STM-64 standard.
PCIX2500 selects clock recovery for the 2.5 Gb/s bit rate, in accordance w ith
the PCI Express Base specification.
SATA1500 selects clock recovery for the 1.5 Gb/s bit rat e, in accordance
with the Serial ATA 1.0a specification.
SATA3000 selects clock recovery for the 3.0 Gb/s bit rate (2nd generation
SATA rate).
SATA6000 selects clock recovery for the 6.0 Gb/s bit rate (potential 3
rd
generation SATA rate).
DSA/CSA/TDS8X00/B Series Programmer Manual 2-307
To Next Page
Loading...
Need help?
General
