Commands Listed in Alphabetical Order
Group
Trigger
Syntax
TRIGger:CLKRec:CRC:EXPrev?
Examples
TRIGGER:CLKREC:CRC:EXPREV? might return
:TRIGGER:CLKREC:CRC:EXPREV xxxx. (xxxx represents the actual board
revision).
NOTE. undefined is returned if a Clock Recovery instrument is not present.
TRIGger:CLKRec:CRC:FPGarev? (Query Only)
This query only command returns the FPGA revision string of the connected
Clock Recovery instrument.
Group
Trigger
Syntax
TRIGger:CLKRec:CRC:FPGarev ?
Examples
TRIGGER:CLKREC:CRC:FPGAREV ? might return
:TRIGGER:CLKREC:CRC:FPGARE V 2.8.
NOTE. undefined is returned if a Clock Recovery instrument is not present.
TRIGger:CLKRec:CRC:HALfrate? (Query Only)
Indicates if the clock outputs of the CRI are at the full-rate or half of the input
signal's data rate.
Group
Trigger
Syntax
TRIGger:CLKRec:CRC:HALfrat e?
Returns
0 indicates the clock recovery instrument is running at full clock rate.
1 indicates the clock recovery instrument is running at half clock rate.
DSA/CSA/TDS8X00/B Series Programmer Manual 2-315
To Next Page
Loading...
