Tektronix DSA8200 Series User Manual

Commands Listed in Alphabetical Order
Group
Trigger
Syntax
TRIGger:PSYNc:CH<x>:PLENg th <nr1>
TRIGger:PSYNc:CH<x>:PLENg th?
Examples
TRIGGER:PSYNC:CH1:PLENGTH 128 defines the pattern length for channel
1 as 128.
TRIGGER:PSYNC:CH1:PLENGTH ? might return
TRIGGER:PSYNC:CH1:PLENGTH 128, i ndicating the current pattern length is
128 for channel 1.
TRIGger:PSYNc:RBIT
This command sets or queries the relative trigger bit of the PatternSync Trigger
module.
Group
Trigger
Syntax
TRIGger:PSYNc:RBIT <nr1>
TRIGger:PSYNc:RBIT?
Examples
TRIGGER:PSYNC:RBIT 5 sets the relative trigger bit to 5.
TRIGGER:PSYNC:RBIT? might return TRIGG ER:PSYNC:RBIT 5 as the relative
trigger bit.
TRIGger:PSYNc:SOUrce
This command sets or queries the pattern sync trigger source. The pattern sync
trigger source is derived from a frame synchronous module (such as the 80A06
PatternSync Trigger Module). The trigger output of the module is routed to the
External Direct trigger input connector on the instrument front panel for triggering.
If you attempt to s et the Pattern Sync source to an unavailable source, you will
receive an Execution Error code 2538 with a message "Pattern Sync Module not
available". (See Messages for general information on programming interface
messages.)
Group
Trigger
2-336 DSA/CSA/TDS8X00/B Series Programmer Manual

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English