Tektronix DSA8200 Series User Manual

Commands Listed in Alphabetical Order
Syntax
TRIGger:PSYNc
:SOUrce {C H<x> | TRIGProbe}
TRIGger:PSYNc:SOUrce?
Arguments
CH<x> is the channel for which you want to set the pattern sync source. The value
forxcanbe1,3,5,7,or
TRIGProbe.
Examples
TRIGGER:PSYNC:SOURCE CH1 sets the source for pattern sync to Channel 1.
TRIGGER:PSYNC:SOURCE?This query might return TRIGGER:PSYNC:SOURCE
CH1
, indicating that Channel 1 is the source for pattern sync.
TRIGger:PSYNc:TRIGProbe:DATARate
This command sets or queries the bit rate (<nr3>) of the PatternSync Trigger
module connected to the TRIGGER PROBE POWER connector. The bit rate
must be in the range available for the module.
The query form returns the bit rate in effect for the module connected to the
TRIGGER PROBE POWER connector.
If you attempt to modify this parameter while the AUTOSync:DATARate is
ON, you will receive Execution Error code 2539 with an error message "Pattern
Sync Parameter is not settable". (See Messages for general information on
programming interface messages.)
Group
Trigger
Syntax
TRIGger:PSYNc:TRIGProbe:DA TARate <nr3>
TRIGger:PSYNc:TRIGProbe:DA TARate?
Examples
TRIGGER:PSYNC:TRIGPROBE:DA TARATE 12.6E9 defines the data rate for the
module connected to the TRIGGER PROBE PO WER connec tor as 12.6 Gb/s.
TRIGGER:PSYNC:TRIGPROBE:DA TARATE? might return
TRIGGER:PSYNC:TRIGPROBE:DA TARATE 12.60000000000E+9,
indicating the current bit rate is 12.6 Gb/s for the module connected to the
TRIGGER PROBE POWER connector.
TRIGger:PSYNc:TRIGProbe:DCRAtio
This command sets or queries the data-to-clock ratio (<nr1>,<nr1>) of the
PatternSync Trigger module connected to the TRIGGER PROBE POWER
connector. The firs t <nr1> value represents the data rate and the second < nr1>
value represents the clock rate.
DSA/CSA/TDS8X00/B Series Programmer Manual 2-337

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English