Tektronix DSA8200 Series User Manual

Commands Listed in Alphabetical Order
One of the data v
alues in the Data/Clock ratio pair must be a 1.
Valid data entries range from 1 to 128. A constraint on the valid range is set by the
Pattern Lengt
h and Data Rate settings.
Invalid entries are ignored, leaving the ratio unchanged.
The query form returns the data-to-clock ratio for the specified channel.
If you attempt to modify this parameter while the AUTOSync:DCRAtio is ON,
you will receive Execution Error code 2539 with an error message "Pattern
Sync Parameter is not settable". (See Messages for general information o n
programmi
ng interface messages.)
Group
Trigger
Syntax
TRIGger:PSYNc:TRIGProbe:D CRAtio <nr1>,<nr1>
TRIGger:PSYNc:TRIGProbe:D CRAtio?
Examples
TRIGGER:PSYNC:TRIGPROBE:D CRATIO 2,1 defines the data-to-clock ratio for
module connected to the TRIGGERPROBEPOWERconnectoras2:1.
TRIGGER:PSYNC:TRIGPROBE:D CRATIO? might return
TRIGGER:PSYNC:TRIGPROBE:D CRATIO 1,2, indicating the current
data-to-clock ratio is 1:2 for the module connected to the TRIGGER PROBE
POWER connector.
TRIGger:PSYNc:TRIGProbe:PLENgth
This command sets or queries the pattern length (<nr1>) of the PatternSync
Trigger module connected to the TRIGGER PROBE POWER connector. The
pattern length must be in the range available for the module.
The query form returns the pattern length for the module connected to the
TRIGGER PROBE POWER connector.
If you attempt to modify this parameter while the AUTOSync:PLENgth is ON,
you will receive Execution Error code 2539 with an error message "Pattern
Sync Parameter is not settable". (See Messages for general information o n
programming interface messages.)
Group
Trigger
Syntax
TRIGger:PSYNc:TRIGProbe:P LENgth <nr1>
TRIGger:PSYNc:TRIGProbe:P LENgth?
2-338 DSA/CSA/TDS8X00/B Series Programmer Manual

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English