Tektronix DSA8200 Series User Manual

Commands Listed in Alphabetical Order
INFPERSIST;CO
UNT 500;S AMPLES 125000; WFMDB:WFMDB4:SOURCE
MATH3,MAG1;DISPLAY 0;ENABLE 0; PERSISTENCE:MODE
INFPERSIST;COUNT 500;SAMPLES 125000
.
WFMDB:DISplay? (Query Only)
This query only command returns all the WfmDB display parameters.
Group
Waveform Database
Syntax
WFMDB:DISplay?
Related Commands
WFMDB?
Examples
WFMDB:DISPLAY? might return WFMDB:DISPLAY:EMPHASIS 50;GRADING
COLOR;INVERT 0
.
WFMDB:DISplay:E
MPHasis
This command sets or queries the display emphasis for the WfmDB (waveform
database). The value you specify sets the range of counts that you want to
emphasize. The l
owest value, 0, emphasizes bins with low counts; the highest
value, 100, emphasizes bins with high counts. You can set the emphasis from
0% to 100%. This command is the equivalent to using the slide bar to set the
Emphasize Counts percentage in the Display Options section of the WfmDB
Setup dialog box.
Group
Waveform Database
Syntax
WFMDB:DISplay:EMPHasis <NR3>
WFMDB:DISplay:EMPHasis?
Related Commands
WFMDB:DISplay:GRADing, WFMDB:DISplay:INVert
Arguments
NR3 is the percentage to which Emphasize Counts is set. The range is from 0
through 100.
Examples
WFMDB:DISPLAY:EMPHASIS 0 sets the instrument to emphasize in the display
bins with low counts.
2-346 DSA/CSA/TDS8X00/B Series Programmer Manual

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English