Commands Listed in Alphabetical Order
OBSAI6144 sele
cts a reference-receiver filter for the 6.144 Gb/s bit rate, in
accordance with the Wireless Base Station OBSAI standard.
OC1 selects a reference-receiver filter for the 51.84 Mb/s bit rate, in accordance
with the Sonet/SDH OC-1/STM-0 standard.
OC3 selects a reference-receiver filter for the 155.52 Mb/s bit rate, in accordance
with the Sonet/SDH OC-3/STM-1 standard.
OC9 selects a reference-receiver filter for the 466.56 Mb/s bit rate, in accordance
with the Sonet/SDH OC-9/STM-3 standard.
OC12 selects a reference-receiver filter for the 622.08 Mb/s bit rate, in accordance
with the Sonet/SDH OC-12/STM-4 standard.
OC18 selects a reference-receiver filter for the 933.12 Mb/s bit rate, in accordance
with the Sonet/SDH OC-18/STM-6 standard.
OC24 selects a reference-receiver filter for the 1.24416 Gb/s bit rate, in accordance
with the Sonet/SDH OC-24/STM-8 standard.
OC36 selects a reference-receiver filter for the 1.86624 Gb/s bit rate, in accordance
with the Sonet/SDH OC-36/STM-12 standard.
OC48 selects a reference-receiver filter for the 2.48832 Gb/s bit rate, in accordance
with the Sonet/SDH OC-48/STM-16 standard.
OC96 selects a reference-receiver filter for the 4.97664 Gb/s bit rate, in accordance
with the Sonet/SDH OC-96/STM-32 standard.
OC192 selects a reference-receiver filter for the 9.95328 Gb/s bit rate, in
accordance with the Sonet/SDH OC-192/STM-64 standard.
OC768 selects a reference-receiver filter f
or the 39.8131 Gb/s bit rate, in
accordance with the Sonet/SDH OC-768/STM-256 standard.
OTU27952 selects a reference-receiver filter for the 27.95 Gb/s bit rate, in
accordance with the Fibre Channel Optical OTU4 standard.
Examples
CH1:FILTER:VALUE NONE disables the filtering for Channel 1.
CH2:FILTER:VALUE? might return CH2:FILTER:VALUE OC12, indicating that
the Sonet/SDH OC-12/STM-4 filter is enabled for Channel 2.
CH<x>:OFFSet
This command sets or queries the vertical offset for the specified channel. The
channel is specified by x, which can be 1 through 8. Setting an offset with this
command is the equivalent to entering a value in the Offset control in the Channel
section of the Vertical Setup dialog box or adjusting the front-panel Vertical
OFFSET knob.
DSA/CSA/TDS8X00/B Series Programmer Manual 2-85
To Next Page
Loading...
Need help?
General
