Tektronix MDO3000 Series Program Manual

Status and Events
Table 3-4: No Ev
ent Messages
Code Message
0 No events to re
port; queue empty
1
No events to r
eport; new events pending *ESR?
Command Error
The following table shows the command error messages generated by improper
syntax. Check that the command is properly formed and that it follows the rules
in the section on command Syntax.
Table 3-5: Command Error Messages (CME Bit 5)
Code Message
100
Command error
101 Invalid character
102
Syntax error
103 Invalid separator
104 Data type error
105
GET not allowed
108 Parameter not allowed
109 Missing parameter
110
Command header error
112 Program mnemonic too long
113
Undefined header
120 Numeric data error
121 Invalid character in numeric
123 Exponent too large
124 Too many digits
130
Suffixerror
131
Invalid suffix
134
Suffix too long
140
Character data error
141 Invalid character data
144
Character data too long
150
String data error
151 Invalid string data
152
String data too long
160 Block data error
161 Invalid block data
170
Command expression error
171 Invalid expression
3-14 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English