Tektronix MDO3000 Series Program Manual

Command Groups
Table 2-42: Ver
tical Commands
Command Description
AUXin?
Returns Aux In
put connector parameters
AUXin:PRObe Returns all information concerning the probe attached to Aux Input connector
AUXin:PRObe:AUTOZero Sets the TekVPI probe attached to the Aux Input connector to autozero
AUXin:PRObe:CALibrate:CALIBRATABLe?
This query i
ndicates w hether the attached probe is calibratable.
AUXin:PRObe:COMMAND Sets the state of the specified probe control
AUXin:PRObe:DEGAUss Starts a degauss/autozero cycle on a TekVPI current probe attached to the
Aux Input connector
AUXin:PRObe:DEGAUss:STATE? Returns the degauss state of the TekVPI current probe attached to the Aux
Input co
nnector
AUXin:P
RObe:FORCEDRange
This com
mand specifies the range of the TekVPI probe attached to the Aux
Input connector
AUXin:PRObe:GAIN This command specifies the gain factor of the probe that is attached to the
Aux Input connector
AUXin:PRObe:ID:SERnumber? Returns the serial number of the probe that is attached to the Aux Input
conne
ctor
AUXi
n:PRObe:ID:TYPe?
Retu
rns the type of probe that is attached to the Aux Input connector
AUXi
n:PRObe:RESistance?
Retu
rns the resistance of the probe that is attached to the Aux Input connector
AUX
in:PRObe:SIGnal
Thi
s command specifies the input bypass setting on VPI probes that support
input bypass
AUXin:PRObe:UNIts? Returns the units of measure of the probe that is attached to the Aux Input
connector
CH<x>? Returns vertical parameters for the specified channel
CH<x>:AMPSVIAVOLTs:ENA ble This command specifies the state of the amps via volts feature for the specified
c
hannel
C
H<x>:AMPSVIAVOLTs:FACtor
T
his command specifies the a mps via volts factor for the specified channel
CH<x>:BANdwidth This command specifies the bandwidth of the specified channel
CH<x>:COUPling This command specifies the coupling setting for the specified channel
CH<x>:DESKew This command specifies the deskew time for the specified channel
CH<x>:INVert This command specifies the invert function for the specified channel
CH<x>:LABel This command specifies the waveform label for channel <x>
CH<x>:OFFSet This command specifies the channel offset
CH<x>:POSition This command specifies the channel vertical position
CH<x>:PRObe? Returns the gain, resistance, units, and ID of the probe that is attached to
the specified channel
CH<x>:PRObe:AUTOZero Sets the TekVPI probe attached to the specified channel input to autozero
CH<x>:PRObe:CALibrate This command executes a calibration or initialization for the probe attached
to the auxilliary input, if the probe is calibratable.
CH<x>:PRObe:CALibrate:CALIBRATAB Le? This query returns the state of the probe attached to channel 1–4, either 0 if
the probe is not calibratable, or 1 if the probe is calibratable.
2-92 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English