Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Related Commands
*CAL?, CALibra
te:RESults:SPC?, CALibrate:INTERNal:STARt,
CALibrate:RF:STATus?
CALibrate:RF:STARt (No Query Form)
This command is identical to CALIBRATE:R F.
NOTE. Disconnect or otherwise remove all input signals prior to starting
self-calibration. The self-calibration can take several minutes to complete .
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
Calibration and Diagnostic
Syntax
CALibrate:RF:STARt
CALibrate:RF:STATus? (Query Only)
This query returns the stat
us of the last RF calibration.
Conditions
MDO3000, MDO4000/B, or MDO4000C mo
dels with option SA3 or SA6 only.
Group
Calibration and Diagnostic
Syntax
CALibrate:RF:STATus?
Related Commands
CALibrate:RF:STARt
Examples
CAL:RF:STAT? might return PASS.
CH<x>? (Query Only)
Returns the vertical parameters for channel <x>, where x is the channel number
(1–4).
Group
Vertical
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-219

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English