Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
AUXin:PRObe:
DEGAUss:STATE? (Query Only)
Returns the state of the probe degauss (NEEDED, RECOMMENDED, PASSED,
FAILED, RUNNING). The command will return PASSED for probes that do not
support dega
uss operations.
Conditions
Available for MSO/DPO4000B series models, 2-channel MDO3000 models, and
MDO4000C m
odels without option SA3 or SA6 only.
Group
Vertical
Syntax
AUXin:PRObe:DEGAUss:STATE?
Example
s
AUXin:PROBE:DEGAUSS:STATE? might return:
AUXin:PROBE:DEGAUSS:STATE PASSED indicating that the probe has been
degaussed.
AUXin:PRObe:FORCEDRange
Changes or returns the range on a TekVPI probe attached to the A
ux Input
connector.
Conditions
Available for MSO/DPO4000B series models, 2-channel MDO30
00 models, and
MDO4000C models without option SA3 or SA6 only.
Group
Vertical
Syntax
AUXin:PRObe:FORCEDRange <NR3>
AUXin:PRObe:FORCEDRange?
Arguments
<NR3> is a floating point number that specifies the probe range, which is probe
dependent.
AUXin:PRObe:GAIN
Specifies the gain factor of a probe that is attached to the Aux Input connector.
Conditions
Available for MSO/DPO4000B series models, 2-channel MDO3000 models, and
MDO4000C models without option SA3 or SA6 only.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-153

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English