Tektronix MDO3000 Series Program Manual

Status and Events
Table 3-6: Execution Error Messages (EXE Bit 4) (cont.)
Code Message
2208
Measurement error, No backwards Mid Ref crossing
2209
Measurement error, No second Mid R ef crossing
2210
Measurement error, No Mid Ref crossing, second waveform
2211
Measurement error, No backwards Mid Ref crossing
2212 Measurement error, No negative crossing
2213 Measurement error, No positive crossing
2214
Measurement error, No crossing, target waveform
2215
Measurement error, No crossing, second waveform
2216
Measurement error, No crossing, target waveform
2217
Measurement error, Constant waveform
2219 Measurement error, No valid edge - No arm sample
2220 Measurement error, No valid edge - No arm cross
2221 Measurement error, No valid edge - No trigger cross
2222 Measurement error, No valid edge - N o second cross
2223
Measurement error, Waveform mismatch
2224 Measurement error, WAIT calculating
2225
Measurement error, No waveform to measure
2226
Measurement error, Null Waveform
2227
Measurement error, Positive and Negative Clipping
2228
Measurement error, P ositive Clipping
2229
Measurement error, Negative Clipping
2230
Measurement error, High Ref < Low Ref
2231 Measurement error, No statistics available
2233
Requested waveform is temporarily unavailable
2235 Math error, invalid m ath description
2240 Invalid password
2241
Waveform requested is invalid
2244
Source waveform is not active
2245
Saveref error, selected channel is turned off
2250
Reference error, the reference waveform file is invalid
2253
Reference error, too many points received
2254
Reference error, too few points received
2259 File too big
2270 Alias error
2271 Alias syntax error
2273 Illegal alias label
2276 Alias expansion error
3-16 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English