Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Examples
ACQUIRE:MODE E
NVELOPE
sets the acquisition mode to display a waveform that
is an envelope of many individual waveform acquisitions.
ACQUIRE:MODE
?
might return:ACQui re:MODe AVERAGE indicating that
the displayed waveform is the average of the specified number of waveform
acquisitions.
ACQuire:NU
MACq? (Query Only)
Returns the number of waveform acquisitions that have occurred since starting
acquisition with the ACQuire:STATE RUN command. This value is reset to zero
when any a
cquisition, horizontal, or vertical arguments that affect the waveform
are changed. The maximum number of acquisitions that can be counted is 2
32
1.
Group
Acquisition
Syntax
ACQuire:NUMACq?
Related Commands
ACQuire:STATE
Returns
ACQuire:NUMACq? might return :ACQUIR E:NUMACQ 350 indicating that 350
acquisitions have occurred since executing an ACQuire:STATE RUN command.
ACQuire:NUMAVg
Specifies the number of waveform acquisitions that should make up an averaged
waveform. Use the ACQuire:MODe command to enable the Average mode.
Sending this command is equivalent to turning a multipurpose knob to enter the
number of waveform acquisitions to average.
Group
Acquisition
Syntax
ACQuire:NUMAVg <NR1>
ACQuire:NUMAVg?
Related Commands
ACQuire:MODe, ACQuire:STATE
Arguments
<NR1> is the number of waveform acquisitions to average. The range of values is
from2to512inpowersoftwo.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-115

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English