Commands Listed in Alphabetical Order
Arguments
POWer sets the a
pplication type to power analysis.
LIMITMask sets the application type to limit mask test.
VIDPic sets the application type to video picture.
ACTONEVent sets the application type to act on event.
NONe
Returns
The query form will return NONe if none of the supported application modules
are installed.
Examples
APPL:TYP? might return LIMITMASK, indicating that the DPO4LMT application
module is currently being used.
AUTOSet (No Query Form)
Sets the vertical, horizontal, and trigger controls of the oscilloscope to
automatically acquire and display the selected waveform.
Group
Miscellaneous
Syntax
AUTOSet {EXECute|UNDo}
Arguments
EXECute autosets the displayed waveform.
UNDo restores the oscilloscope settings to those present prior to the autoset
execution.
Examples
AUTOSET EXECUTE vertical, horizontal, and trigger controls of the oscilloscope to
automatically acquire and display all waveforms which are turned on.
AUTOSet:ENAble
Enables or disables the autoset feature. This is useful for classroom purposes
where the instructor wants the students to achieve the desired instrument settings
without the benefit of the autoset feature. This setting is not saved in setupfilesor
SET? or *LRN? queries. The default state is 1 (autoset enabled).
Group
Miscellaneous
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-149
To Next Page
Loading...
Need help?
General
