Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Returns
<NR1> = 1 if the a
dvanced RF feature is present.
<NR1> = 0 if the advanced RF feature is not present.
CONFIGuration:RF:BANDWidth? (Query Only)
This query returns the bandwidth, in Hz, for the RF channel(s). If there are no
RF channels, the value returned is 0.
Group
Configuration
Syntax
CONFIGuration:RF:BANDWidth?
Returns
Floating point number that represents the bandwidth, in Hz, for the RF channel.
CONFIGuration:RF:MAXBANDWidth? (Query Only)
This query returns the maximum bandwidth, in hertz, for RF channels. If no
RF channels are present, the query returns 0. Enabling this feature requires an
MDO4000/B/C Series oscilloscope and installation of a MDO4TRIG application
module.
Group
Configuration
Syntax
CONFIGuration:RF:MAXBANDWidth?
Related Commands
(See page 2-47, RF Command Group .)
Returns
<NR3>, which is a floating point number that represents the maxi
mum RF
bandwidth, in hertz.
CONFIGuration:RF:NUMCHANnels? (Query Only)
This query returns the number of RF channels present. If no RF channels are
present, the query returns 0. )
Group
Configuration
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-255

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English