Commands Listed in Alphabetical Order
Related Commands
MASK:TESt:STA
TE,
MASK:TESt:COMPLetion:CRITerion
Arguments
ON turns on this feature, so that upon the completion of a mask test, the instrument
will send an SRQ command (if registers are set to send SRQ when OPC is
asserted. (See page 3-1, Registers.))
OFF turns off this feature.
<NR1> is an integer. 0 turns off this feature; any other integer turns it on.
Examples
MASK:TESt:SRQ:COMPLetion ON sends an SRQ command upon test
completion.
MASK:TESt:SRQ:COMPLetion? might return 0, indicating the instrument is not
settosendanSRQcommandupon test completion.
MASK:TESt:SRQ:FAILure
This command causes the instrument to send an SRQ command when a pass/fail
mask test fails.
A series of examples showing how to use mask commands for typical tasks
is included in an appendix. (See page E-1, Mask/Limit Command Sequence
Examples.)
Conditions
This command requires a DPO4LMT application module for 4000 series models,
andanMDO3LMTapplicat
ion module for MDO3000 series models.
Group
Mask
Syntax
MASK:TESt:SRQ:FAILure {ON|OFF|<NR1>}
MASK:TESt:SRQ:FAILure?
Related Commands
MASK:TESt:STATE,
MASK:TESt:COMPLetion:CRITerion
Arguments
ON turns on this feature, so that when a mask test fails, the instrument will send
an SRQ command (if registers are set to send SRQ when OPC is asserted. (See
page 3-1, Registers.)).
OFF turns off this feature.
2-392 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
