Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
POWer:QUALit
y:DISplay:FREQuency
This command specifies the display state for the frequency readout.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:QUALity:DISplay:FREQuency {OFF|ON|0|1}
POWer:QUALity:DISplay:FREQuency?
Arguments
OFF or 0 turns off the frequency display.
ON or 1 turns on the frequency display.
Examples
POWER:QUALITY:DISPLAY:FREQUENCY 1 turns on the frequency readout
display.
POWER:QUALITY:DISPLAY:FREQUENCY? might return
:POWER:QUALITY:DISPLAY:FREQUENCY 0 indicating that the
frequency readout display is off.
POWer:QUALity:DISplay:ICRESTfactor
This command specifies the display state for the current crest factor readout.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:QUALity:DISplay:ICRESTfactor {OFF|ON|0|1}
POWer:QUALity:DISplay:ICRESTfactor?
Arguments
OFF or 0 turns off the current crest factor display.
ON or 1 turns on the current crest factor display.
Examples
POWER:QUALITY:DISPLAY:ICRESTFACTOR 1 turns on the current crest factor
display.
2-490 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English