Tektronix MDO3000 Series

Commands Listed in Alphabetical Order
Syntax
POWer:QUALity
:VRMS?
Examples
POWER:QUALITY:VRMS? might return :POWER:QUALIT Y:VRMS 115 indicating
that the rms voltage value is set to 115 V.
POWer:REFLevel:ABSolute (No Query Form)
This command sets the reference levels to be used for power measurements their
default unit values.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:REFLevel:ABSolute {SETTODEFaults}
Arguments
SETTODEFaults sets the reference levels to their default values.
POWer:REFLevel:ABSolute:HIGH
This command specifies the top reference level to be used for power
measurements.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:REFLevel:ABSolute:HIGH <NR3>; Ranges={D,-1e6,+1E6}
POWer:REFLevel:ABSolute:HIGH?
Arguments
<NR3> is a floating point number that specifies the absolute high value in volts.
Default value is 0.0E+0
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-499