Commands Listed in Alphabetical Order
Syntax
POWer:REFLeve
l:ABSolute:MID<x> <NR3>; Ranges={D,-1e6,+1E6}
POWer:REFLevel:ABSolute:MID<x>?
Arguments
<NR3> is a floating point number that specifies the absolute mid reference value.
Examples
POWER:REFLEVEL:ABSOLUTE:MID1 1 sets the mid reference voltage to 1V.
POWER:REFLEVEL:ABSOLUTE:MID1? might return
POWER:REFLEVEL:ABSOLUTE:MID1 0.0E+0 indicating that the absolute
reference voltage level is set to 0.0E+0 V.
POWer:REFLevel:HYSTeresis
This command specifies the reference level hysteresis value to be used for power
measurements.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:REFLevel:HYSTeresis <NR3>
POWer:REFLevel:HYSTeresis?
Arguments
<NR3> is a floating point number that specifies the hysteresis value.
Examples
POWER:REFLEVEL:HYSTERESIS 30 sets the hysteresis value to 30.
POWER:REFLEVEL:HYSTERESIS? might return
POWER:REFLEVEL:HYSTERESIS 10 indicating that the hysteresis value is
set to 10.
POWer:REFLevel:METHod
This command specifies the method used to calculate the 0% and 100% reference
level to be use
d for power measurements.
Conditions
This command requires a DPO4PWR application module for 4000 series model
s,
or an MDO3PWR application module for MDO3000 series models.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-501
To Next Page
Loading...
Need help?
General
